

IEC 60384-17-2019 電子設備用固定電容器--第17部分:分規范--固定金屬化聚丙烯薄膜介質交流和脈沖電容器 Fixed capacitors for use in electronic equipment – Part 17: Sectional specification – Fixed metallized polypropylene film dielectric AC and pulse capacitors
- 標準類別:
- 標準大?。?/li>
- 標準編號:IEC 60384-17-2019
- 標準狀態:現行
- 更新時間:2023-05-17
- 下載次數:次
This part of IEC 60384 applies to fixed capacitors with metallized electrodes and polypropylene dielectric for use in electronic equipment.
NOTE Capacitors that have mixed film and metallized electrodes are also within the scope of this standard.
These capacitors may have "self-healing" properties depending on conditions of use.
Capacitors covered by this specification are mainly intended for use with alternating voltage and/or for pulse applications. The maximum reactive power applicable is 10 000 var and the maximum peak voltage is 3 000 V.
Capacitors for reactive power exceeding 500 var, and to which a maximum peak voltage of 2 500 V at 50 Hz can be applied, are not covered by this document, except when they are the highest part of a range of reactive power mainly situated below 500 var at 50 Hz.
This document is not intended to cover capacitance values higher than 20 µF.
Two performance grades of capacitors are covered, Grade 1 for long-life application and Grade 2 for general application.
Capacitors for electromagnetic interference suppression are not included, but are covered by IEC 60384-14.
Capacitors for electrical shock hazard protection (covered by IEC 60065 of IEC technical committee 61) and fluorescent lamp and motor capacitors (covered by IEC 60252-1 and IEC 60252-2 of IEC technical committee 33), and capacitors for use in tubular fluorescent and other discharge lamp circuits (covered by IEC 61048 and IEC 61049 of IEC technical committee 34) are also excluded.dition 3.0 2019-03
INTERNATIONAL
STANDARD
NORME
INTERNATIONALE
Fixed capacitors for use in electronic equipment –
Part 17: Sectional specification – Fixed metallized polypropylene film dielectric
AC and pulse capacitors
Condensateurs fixes utilisés dans les équipements électroniques –
Partie 17: Spécification intermédiaire – Condensateurs fixes pour tension
alternative et pour impulsions à diélectrique en film de polypropylène métallisé
IEC 60384-17:
標準截圖
-
GB/T 1094.1-2013電力變壓器 第1部分:總則 2023-05-17
-
GB/T 706-2016熱軋型鋼 2023-05-17
-
GB 9706.1-2020醫用電氣設備 第1部分:基本安全和基本性能的通用要求 2023-05-17
-
JB/T 10216-2013電控配電用電纜橋架 2023-05-17
-
GB 51251-2017建筑防煙排煙系統技術標準 2023-05-17
-
GB/T 10801.2-2018絕熱用擠塑聚苯乙烯泡沫塑料(XPS) 2023-05-17
-
JTG D20-2017公路路線設計規范 2023-05-17