ASTM D2712-2017 用氣相色譜法測定丙烯濃縮物中痕量烴的試驗方法 Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography ASTM D2712-2017 用氣相色譜法測定丙烯濃縮物中痕量烴的試驗方法 Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography

ASTM D2712-2017 用氣相色譜法測定丙烯濃縮物中痕量烴的試驗方法 Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography

  • 標準類別:
  • 標準大?。?/li>
  • 標準編號:ASTM D2712-2017
  • 標準狀態:現行
  • 更新時間:2023-05-01
  • 下載次數:次
標準簡介

1.1 This test method is used for the determination of hydrocarbon impurities in Propylene (propene) material of 97 % by mass or greater purity (concentrates). These impurities are determined in the concentration range of 0.35 mg/kg to 8575 mg/kg and includes the following components, methane, ethane, ethylene, propane, acetylene, isobutane, propadiene, normal butane, trans-2-butene, butene-1, isobutylene, cis-2-butene, isopentane, methylacetylene, normal pentane, and 1,3-butadiene. Note 1: Optionally, the analysis may include the determination of pentenes/hexanes and heavier components, see 6.3. 1.2 This method does not determine non-hydrocarbon impurities, and additional tests may be necessary to fully characterize the propylene sample. However, for the purposes of this test, the purity of propylene is determined as the difference between the total of the determined analytes and 100 % (by difference). 1.3 When this method is being used for the determination of trace level impurities in high-purity propylene, the use of this method for the analysis of propylene samples at lower purities is not recommended due to the potential for cross contamination between samples. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued

標準截圖
版權:如無特殊注明,文章轉載自網絡(luò ),侵權請聯系cnmhg168#163.com刪除!文件均為網友上傳,僅供研究和學習使用,務必24小時內刪除。
欧美AAAAAA级午夜福利_国产福利写真片视频在线_91香蕉国产观看免费人人_莉莉精品国产免费手机影院